Roland SH-1000 Socket Kit
£79.20 to £147.20 ex VAT
£95.04 to £176.64 inc VAT
PLEASE NOTE: Fitting a socket upgrade kit is a skilled job which should be undertaken only by a competent synth service engineer or fitted by us at our premises in Epsom, just outside London.
This is the Socket Kit for the SH-1000. If you wanted the MIDI Retrofit Kit, see Roland SH-1000 MIDI Retrofit Kit.
Kit to add CV / Gate / Filter sockets to the Roland SH-1000
When used in conjunction with one of our MIDI to CV converters, such as the Pro-Solo mkII or Pro-2000 mkII, these three additional sockets will enable the synth to be played from a MIDI keyboard or MIDI sequencer.
The inputs are on 3.5mm mono jack sockets which provide the following control:
CV – provides Volt per Octave control over the oscillator frequency
Gate – controls when notes play (0 volts = note off / >3 volts = note on)
Filter – controls the cutoff frequency of the low pass filter (from aux out of converter)
The kit contains a circuit board and all necessary components and diagrams for connecting the wires / components, and mounting the three 3.5mm mono jack sockets.
Used with a Pro-Solo mkII or Pro-2000 mkII this kit will give you the following control over the synth from a suitable MIDI keyboard or sequencer:
Notes – at least 5 octaves range – (this is not limited by the kit or converter, but by the synth itself)
Pitchbend – range can be set in the converter
Modulation – from converter’s inbuilt LFO. Speed and waveshape can be changed in real time.
Portamento (slide) – rate can be changed in real time.
Filter cutoff frequency – can be controlled using any continuous MIDI controller (cc) or other MIDI message such as Aftertouch or Velocity
Low / High / Recent note priority – can be set in the converter
Single / Multiple note trigger modes – can be set in the converter
See the specifications of the Pro-Solo mkII or Pro-2000 mkII for further features.
How to connect using our MIDI to CV Converters