Firmware update for Pro 2
This product cannot be re-flashed. An EPROM chip must be replaced to upgrade the firmware.
£18 ex VAT
£21.60 inc VAT
Description
For firmware 4031.071 the firmware version can be ascertained by holding the inc & dec buttons pressed while powering the unit on. The display will show four sets of 2 digits continuously while the buttons are pressed e.g. 40-31-00-71 for the 4031.071 version.
For earlier versions the cover must be removed and the label on the eprom looked at to ascertain the firmware version. Ensure that the unit is unplugged from the mains supply before removing cover, and that the cover and screws are replaced before reconnecting.
Pro 2 firmware history |
||
01/11/1996 | K3CV4032.0042 | added off to controllers (goes to reset value) |
29/10/1996 | K3CV4032.0036 | pitch bend centre facility added |
30/09/1995 | K3CV4032.0028 | allow arp clk to do 24 ck/qn |
25/09/1995 | K3CV4032.0025 | put arp clk into new sy24 system |
16/07/1995 | K3CV4032.0015 | changes to sy24 |
12/04/1995 | K3CV4031.0085 | omni-on flag now ignored |
08/12/1994 | K3CV4031.0080 | changed optional tr606 routines to handle tr808 also |
01/12/1994 | K3CV4031.0079 | changed midi monitor mode to default to midi note # |
09/09/1994 | K3CV4031.0071 | panel display of software rev + midi monitor mode added |
For the following versions the cover must be removed and the label on the eprom looked at to ascertain the firmware version. Ensure that the unit is unplugged from the mains supply before removing cover, and that the cover and screws are replaced before reconnecting. | ||
18/05/1994 | K3CV4030 | TR-606 routines removed ? |
10/01/1994 | K3CV4229 | added tr-606 routines – corrected bug in iw (wasp) setup |
05/06/1993 | K3CV4028 | changed arp clk to give more equal hi & lo pulses |
14/12/1992 | K3CV4027 | removed experimental zipper noise reduction |
10/12/1992 | K3CV4026 | multiple notes off – reduce zipper noise |
19/09/1992 | K3CV4025 | can be factory set to include wasp or not |
30/08/1992 | K3CV4024 | improved test procedures |
30/08/1992 | K2CV4023 | put optional wasp port on separate channel |
24/05/1992 | K2CV4020 | added new note takes precedence & quick test mode |
24/05/1992 | K2CV4019 | arp 2600 trigger improved |
14/05/1992 | K2CV4018 | added arp clk & sync skt test |
14/05/1992 | K2CV4017 | corrected 9s – added self test for eeprom |
04/05/1992 | K2CV4016 | add range |
04/05/1992 | K2CV4015 | auto repeat added |
02/05/1992 | K2CV4014 | push button bug cured |
02/05/1992 | K2CV4013 | trigs |
30/04/1992 | K2CV4012 | removed original minimum settings – now initial offset |